When selecting the “Maximum Current” for the group (this is remembered even if offline), please follow this chart:ġ00A circuit breaker = 80A Maximum Current (A)-JuiceBox 75 or 80 onlyĥ0A circuit breaker = 40A Maximum Current (A)-JuiceBox 40 onlyĤ0A circuit breaker = 32A Maximum Current (A)-JuiceBox 32 only Select + New Load Group and give it a name and shared amperage rating (this is 80% of the circuit breaker) Go to and login (same as your app login) and under My JuiceNet select Load Groups. To set up a Load Sharing Group, follow these steps: For example, a 50 amp circuit for two or more Pro 40 units would split the available 40A, It will allow a combined output per the NEC 125% rule. Once you have the JuiceBoxes wired up and connected to WiFi, please add them to a Load Group. Pro 32 with same must only go on a 40A breaker, and nothing larger.Pro 40 with same must only go on a 50A breaker, and nothing larger.Pro 75/80 with same must only go on a 100A breaker, and nothing larger.Please note when setting up your load sharing, that the overcurrent device (Circuit Breaker) cannot exceed the rated amount of a normal JuiceBox installation. The disconnecting means shall be lockable open in accordance with 110.25. For equipment rated more than 60 amperes or more than 150 volts to ground, the disconnecting means shall be provided and installed in a readily accessible location. (3) Password protected commissioning software accessible only to qualified personnelĦ25.43 Disconnecting Means. (2) Locked doors accessible only to qualified personnel (1) A cover or door that requires the use of a tool to open Restricted access shall be accomplished by at least one of the following: Restricted access shall prevent the user from gaining access to the adjusting means. Sizing the service and feeder to match the adjusting means shall be permitted. Electric vehicle supply equipment with restricted access to an ampere adjusting means shall be permitted to have ampere ratings that are equal to the adjusted current setting. If adjustments have an impact on the rating label, those changes shall be in accordance with manufacturer’s instructions, and the adjusted rating shall appear with sufficient durability to withstand the environment involved on the rating label. Where an automatic load management system is used, the maximum equipment load on a service and feeder shall be the maximum load permitted by the automatic load management system.Īdjustable settings shall be permitted on fixed-in-place equipment only. Service and feeder shall be sized in accordance with the product ratings. Electric vehicle charging loads shall be considered to be continuous loads for the purposes of this article. The power transfer equipment shall have sufficient rating to supply the load served. This revision provides relief from service upgrades in some cases, but an automatic load management system has to limit the load on the service to its capacity.Ħ25.42 Rating. The maximum electric vehicle supply equipment load on a service and feeder shall be the maximum load permitted by the automatic load management system. A new last sentence that includes provisions for an automatic load management system has been added to 625.41.

Good news, the JuiceNet servers allow you to share one electrical circuit safely while charging both vehicles.Ħ25.42 Electric Vehicle Supply Equipment Circuit Ratingįormer 625.14 has been revised and relocated to 625.41 as a result of Article 625 being reorganized. You just installed and added your second of two JuiceNet enabled devices, but only have one electrical circuit.

Evse level 2 juicebox pro